Front Right Turn Signal Light 5. An imbalance of less than 10 grams 0. Dispose of used oil properly. Slots Install the washers and collar. Be sure to maintain proper alignment and use smooth movements when installing. . Standard 1 click In from the fully seated position turned fully counterclockwise.
Clamp Insert the clamp to the handle. Dispose of used oil properly. Rear Suspension: Type Swingarm uni-trak Wheel Travel 145 mm 5. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. If the clearance is between 0. The brake light should ing the adjusting nut.
If the clearance is within the standard, no bearing replace- ment is required. If handlebars by an authorized Kawasaki dealer. Fuel Pressure Idling Standard: 294 kPa 3. Air Cleaner Drain Hose 3. Main Fuse 30 A 8. Right Switch Housing Lead 4.
Ignition Fuse 10 A 9. Ask an authorized Kawasaki dealer for inspection and maintenance. If the seat width is within the specified range, lap the valve to the seat as described below. Because of the danger of highly flammable liquids, do not use gasoline or a low-flash point solvent to clean the element. Read Owner's Manual, see page 11 3. Subthrottle Valve Actuator Drive Signal 1 29.
Through the front wheel rotation sensor lead to the outside of the main harness. Through the main harness to the rear fender front opening. Clamp the main harness, and insert it in the rear fender front. Special Tool - Fork Piston Rod Puller, M10 × 1. Ignition Fuse 10 A 5. Thrust Washer, 30 mm 1. Front Left Turn Signal Light 6.
If the gap is too narrow, the clutch may not engage fully. Headlight low connector with green tape on the headlight lead. Do not touch the spark plugs or stick coils while the engine is running, or you could receive a severe electrical shock. Tire and Load Data 8. Install the hook faces downward. This will burn out the diodes on the electrical parts.
If there is any doubt as to the condition of the reeds, re- place the air suction valve as an assembly. Main throttle sensor trouble Inspect see chapter 3. Therefore the cutter must not be used for other purposes than seat repair. Do not use any other battery except for a 12 V sealed battery as a power source. Only appropriate permanent internal repairs are recommended. L: Apply a non-permanent locking agent.
Torque - Upper Handlebar Holder Bolts: 25 N·m 2. Match clearance in vertical column with present shim size in horizontal column. Joint Connector Delay Unit 15. Unleaded gasoline, see page 56. . Place a strip on each journal parallel to the camshaft installed in the correct position.
Ask an authorized Kawasaki dealer for inspection and maintenance. Aluminum wheels, both force near the following places. Swelling or high spots indicate inter- nal damage, requiring tire replacement. The relays and diodes can not be removed. Do not turn the adjuster beyond the fully seated position or the adjusting mechanism may be Suspension System. Always install a fuse 5 A or less for the circuit.